Service manual

ENGINE
CYLINDER HEAD REMOVAL
NOTE: Cam chain and tensioner must be removed.
If no crankshaft service is being performed, secure cam
chain with mechanics wire to avoid chain drop into the
crankcase.
1. Loosen each of the four cylinder head bolts evenly
1/4 turn each time in a cross pattern until loose.
2. Remove the cylinder bolts and tap the cam support
tower with a plastic hammer until loose. Remove.
3. After removing the the camshaft and securing the
cam chain, tap cylinder head lightly with a plastic
hammer until loose.
CAUTION
Tap only in reinforced areas or on thick parts of
cylinder head casting to avoid damaging casting.
4. Remove the thermostatic.
4. Remove intake manifold nuts.
5. Remove cylinder head and head gasket.
4.12