Service manual

CVT SYSTEM
8. Remove the primary sliding sheave and cam plate
assembly (D) as one assembly.
2. Remove the nut by pincer and air wrench.
3. Pull the entire clutch off as an assembly.
The re-coil starter bolts must with loctite when
recombination.
Spike load system Removal
NOTE: This assembly utilizes a torque limiting system
to prevent transmission damage. Use care removing
the clutch assembly, as the torque—limiting
components become free and could fall apart. Mark or
note parts during disassembly.
1. Remove the driven clutch assembly by releasing the
set screw and removing the nut from the shaft.
3.7