Service manual

ELECTRICAL
6.2 Press right button to setting tire diameter. If you pass the
desire number continue pressing right button it will repeat
again.
The setting code from d 15-0 to d 28-7.
The setting code show as following table
Tire Spec. Rim OD. Tire OD.
Tire
circle
Code
18x7-7 7 inch 457 mm
1436 mm
d 18-0
18x9.5-8
8 inch
459 mm 1441 mm d 18-0
20x9-8
8 inch
508 mm 1595 mm d 20-0
20x10-9
9 inch
508 mm 1595 mm d 20-0
21-8-9
9 inch
536 mm 1683 mm d 21-0
21x7-10
10 inch
536 mm 1683 mm d 21-0
22x8-10
10 inch
561 mm 1763 mm d 22-0
23x8-11
11 inch
588 mm 1842 mm d 23-0
IGNITION SYSTEM
RPM LIMITER SPECIFICATIONS
NOTE: The ATV is limited through the CDI box located on
the bulkhead under the front cab. In forward gear, the CDI
reads the RPM’s from the stator. The CDI acts as a limiter
when the peak RPM is met. In Reverse Gear, the CDI also
limits RPM, taking a signal from the shift drum switch that
the vehicle is in reverse.
IGNITION COIL TESTING
Test Description Resistance
Spade Connection to
Ground
0.5 -- 1.0 Ohms
Plug Cap (Cap Resistance
with Cap Removed)
4--5 K Ohms
Ignition Coil Secondary
Winding (Cap Removed)
5--9 K Ohms
ALTERNATOR OUTPUT TEST (AC AMP)
Three tests can be performed using a multimeter to
determine the condition of the stator (alternator).
9.13