Service manual

ELECTRICAL
4. Observe headlight aim. The most intense part of the
headlight beam should be aimed 5.1 cm (2”) below the
mark placed on the wall.
NOTE: Rider weight must be included on the seat. For
machines with separate low beam lights, the drop
should be 20.3 cm (8〃) in 25’.
5. Adjust beam to desired position by moving headlight.
Taillight
Taillight Lamp Replacement
If the tail light lamp does not work, the lamp may need to be
replaced.
1. Remove the two screws securing the lens cover. Remove the
lens cover.
2. Remove the LED lamp and replace it with a new
recommended LED lamp. Apply Dielectric Grease to the lamp
terminals.
3. Test the light for proper operation.
4. Reinstall the lens cover.
9.8