Service manual

ELECTRICAL
Headlight Lamp Replacement
If the headlights do not operate, lamp replacement may be
required. Install only the recommended replacement lamps.
1. Remove the socket rubber seal.
2. Remove the socket rubber seal.
3. Remove the plug and replace bulb.
4. Pull the position bulb and replace it.
4. Reinstall the socket into the housing and Start the engine
to make sure the lights come on. If the lights do not
operate, check the charging system and related wiring for
possible malfunction.
Headlight Adjustment
The headlight beam can be adjusted up and down and
side to side.
1. Place the vehicle on a level surface with the headlight
approximately 7.6 m (25’) from a wall.
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the same
height.
3. Shift transmission to neutral, start the engine and turn
the headlight switch to high beam.
9.7