Service manual

ELECTRICAL
Switch Installation
5. Once repairs are completed, reinstall the shift pin and
spring into the shift drum (arrow). NOTE: assembly lube
can be used to “stick” parts together for ease of assembly.
6. Install the indicator switch and o--ring (arrow), routing
the wires in the same manner as during disassembly.
7. Install the retaining screws. Torque to 5Nm (45 in. lbs).
SWITCH SERVICE
Brake Lever Switches
Each brake lever utilizes an electrical brake switch that sends
voltage to activate the brake light.
1. Locate the brake switches on each of the brake levers.
2. Disconnect wire harness from brake switch and connect an
ohmmeter across the two switch wires.
The reading should be infinite (•).
3. Apply brake the brake lever(s) and check for continuity
between switch contacts. Replace switch if there is no continuity
or if the resistance is greater than .5 ohms when the brake is
applied with slight pressure.
9.4