Service manual

BRAKES
4. The shunt system is hydraulically actuated.
◎When the right foot brake lever (master cylinder) is applied,
the two front brake calipers and a rear caliper are active and
under pressure.
◎When the right front brake lever (master cylinder) is applied,
the two front brake calipers are active and under pressure.
◎When the right front brake lever (master cylinder) is applied,
the rear brake caliper is active and under pressure.
8. Remove the disc blots then disc.
9. Remove the speedometer sensor.
10. The front left hand brake use same procedure.
Shunt Removal
1. Remove two mounting bolts under frame.
2. Remove all banjo bolts then shunt.
3. Inspect two piston’s o-ring and rubber cups surface for wear
or other damage. Replace an assembly if necessary.
FRONT BRAKE – BLEEDING/ FLUID
CHANGE
NOTE: This procedure should be used to change fluid or
bleed brakes during regular maintenance.
8.8