Service manual

BRAKES
SPECIFICATIONS
General Specifications
Front Brake Disc
Item Standard Service Limit
Brake Pad Thickness
7.6 mm (0.298”) 4.3 mm (0.17”)
Brake Disc Thickness
4mm (0.16”) 3.5mm ( 0.14”)
Brake Disc Thickness Variance
Between Measurements
--
0.05mm ( 0.002”)
Brake Disc Runout
--
0.25mm (0.01”)
Rear Brake Disc
Item Standard Service Limit
Brake Pad Thickness
7.8 mm (0.20”) 4.5 mm (0.18")
Brake Disc Thickness
4.2 mm (0.17”) 3.8mm (0.15”)
Brake Disc Thickness Variance
Between Measurements
--
0.05mm ( 0.002”)
Brake Disc Runout
--
0.25mm (0.01”)
Torque Specifications
Item Torque
(Nm)
Torque
(ft. lbs. except where noted*)
Front Caliper Mounting Bolts
25 18
Rear Caliper Mounting Bolts
42 31
Master Cylinder Reservoir
Cover Bolts
0.6 5 in.lbs.
Brake Line Banjo Bolt
20 15
Brake Disc Mounting Bolts
29 21.4
Caliper Bleed Screws
3 27 in.lbs.
Foot Brake Master Cylinder
Mounting Bolt
25 18
Shunt Mounting Bolt
20 15
NOTE: Refer to the tightening procedures in this chapter when torquing the bolts. Some special procedures
are used when torquing certain bolts and fasteners.
8.2