Service manual

BODY / SUSPENSION / STEERING
HANDLEBAR BLOCK INSTALLATION
PROCEDURE
1. Position the two steering post blocks (D) properly onto the
handlebars.
2. Install the front block bolts (A) first and evenly tighten
the bolts down. Evenly torque the 2 front bolts to
15--18 Nm (11--13 ft.lbs.).
3. Install the rear bolts (B) and tighten evenly. Evenly
torque the 2 rear bolts to 15--18 Nm (11--13 ft.lbs.).
4. Install the four handlebar bolts and pod bracket (C)
loosely into the blocks.
5. Install the handlebar pod (E) and screws (F).
NOTE: There will be a slight gap on the backside of
the blocks after the procedure is performed.
7.16