Service manual

ATX 300 Plus Boost Operation Manual | Version 1 | September 2011 Robert Bosch LLC
6 | Cooler Mode | Connecting to the Transmission System
Connecting to the Transmission System — Cooler Mode
1. Add desired amount of transmission fluid to the new fluid tank through the ATX 300 PLUS BOOST fill port. Monitor
fluid level in the ATX 300 PLUS BOOST with the LED readouts or with fluid sight indicators. Do not pour more than
25 quarts of new transmission fluid to the new fluid tank.
2. Locate and disconnect the transmission cooler lines at the most convenient location:
A. At cooler line connecting to radiator usually most accessible if vehicle is not on lift.
B. At clamped rubber hose connection to transmission cooler usually most accessible if vehicle is on a lift. Cooler
is most often in front of the radiator.
C. At cooler line connecting to the transmission usually requires vehicle to be on a lift.
Important
Check transmission fluid level according to manufacturer’s instructions before connecting the
ATX 300 PLUS BOOST. Adjust fluid level if required.