Service manual

Robert Bosch LLC ATX 300 Plus Boost Operation Manual | Version 1 | September 2011
Keypad Functions | 5
Used after the exchange process if fluid level is too high on the transmission dipstick. Removes
½ quart of fluid from the transmission. The ATX 300 PLUS BOOST buzzer will sound continuously
until the stop button is pushed when procedure is complete. Refer to page 9 for cooler mode and
page 13 for dipstick mode for complete instructions.
Used after the exchange process if fluid level is too low on the transmission dipstick. Adds ½
quart of transmission fluid to the transmission from the ATX 300 PLUS BOOST new fluid tank.
The ATX 300 PLUS BOOST buzzer will sound continuously until the stop button is pushed when
procedure is complete. Refer to page 9 for cooler mode and page 13 for dipstick mode for
complete instructions.
Stops any procedure the moment it is pushed, also used at the end of a procedure to
acknowledge completion of process and turn buzzer off.
Illuminates when battery connection is backwards.
Illuminates when the used tank is too full or flashes when the capacity remaining is less than
exchange amount selected. The EMPTY Used procedure must be run to continue operation of the
ATX 300 PLUS BOOST.
Illuminates when the new fluid tank is empty or flashes when the new fluid level is less than the
selected exchange amount. The operator must add fluid to the new fluid tank of the ATX 300
PLUS BOOST through the fill port.
Illuminates when the vehicle engine is running and connected properly to the ATX 300
PLUS BOOST.
Illuminates when the selected process is complete. The buzzer will sound continuously when this
is illuminated.
The ATX 300 PLUS BOOST provides two modes of fluid exchange - Cooler or dipstick mode. The
mode is selected using these buttons when the ATX 300 PLUS BOOST is powered up. During
dipstick mode, the start engine button is pressed at a specified step.
Two LED readouts display the amount of fluid in the New and Used fluid tanks and give real-time
readouts as the different procedures run.
Caution
Always use fingers to operate keypad. Use of sharp objects will cause damage and void
the warranty.