Service manual

ATX 300 Plus Boost Operation Manual | Version 1 | September 2011 Robert Bosch LLC
14 | Empty Used
Empty Used — Common for both modes
1. Connect red (positive) clamp on ATX power cable to red (positive) terminal on vehicle battery. Connect the black
(negative) clamp to a ground on vehicle frame. Vehicle engine is turned OFF. The ATX 300 PLUS BOOST 10 ft
black and red hoses must be disconnected from the transmission. READY light is off.
2. Place end of 8 ft black hose (left side of ATX 300 PLUS BOOST) in bulk used fluid container. Attach short black
adapter hose with open end to coupler on end of 8 ft black hose.
3. Press the EMPTY USED button on the keypad.
4. Buzzer will sound and used transmission fluid will empty from the used tank inside the ATX 300 PLUS BOOST to
the bulk container. Level can be viewed on used LED readout or through the Level Indicator on the left side of the
ATX 300 PLUS BOOST.
5. Procedure will run until used tank is completely emptied or the STOP button is pressed. If process is allowed
to run until completion (30 seconds after used fluid tank is empty), the buzzer will sound continuously and the
PROCESS COMPLETE light will stay illuminated until the STOP button is pressed.
6. Remove short black adapter hose on the 8 ft black hose and remove it from the bulk used fluid container.
Empty New — Common for both modes
1. Connect red (positive) clamp on ATX power cable to red (positive) terminal on vehicle battery. Connect the black
(negative) clamp to a ground on vehicle frame. Vehicle engine is turned OFF. The ATX 300 PLUS BOOST 10 ft black
and red hoses must be disconnected from the transmission. READY light is off.
2. Couple any fitting adapter to the end of the 10 ft red hose (right side of ATX 300 PLUS BOOST). Place end of hose
in bulk storage container.
3. Press the EMPTY NEW button on the keypad.
4. Buzzer will sound and new transmission fluid will empty from the new tank inside the ATX 300 PLUS BOOST
to the bulk storage container. Level can be viewed through the Level Indicator on the right side of the ATX 300
PLUS BOOST.
5. Procedure will run until new tank is completely emptied or the STOP button is pressed. If process is allowed to run
until completion (30 seconds after new fluid tank is empty), the buzzer will sound continuously and the PROCESS
COMPLETE light will stay illuminated until the STOP button is pressed.
6. Disconnect fitting adapter from end of the 10 ft red hose.