Service manual

Robert Bosch LLC ATX 300 Plus Boost Operation Manual | Version 1 | September 2011
Dipstick Mode | Connecting to the Transmission System | 11
Connecting to the Transmission System — Dipstick Mode
1. Remove transmission dipstick.
2. Hold notched end of Dip Tube Hose even with the end of the dipstick as shown above.
3. Position Slide Indicator so that Dip Tube Hose will insert one inch deeper into the transmission.
Important
Check transmission fluid level according to manufacturer’s instructions before connecting the
ATX 300 PLUS BOOST. Adjust fluid level if required.
4. Insert notched end of Dip Tube Hose into transmission so that the Slide Indicator is even with the top of the
dipstick port as shown above.
5. Attach Quick Coupler to other end of Dip Tube Hose.
6. Insert Quick Coupler into fitting on end of the black hose on the left side of the ATX 300 PLUS BOOST.
Do not use small dip tube hose unless absolutely necessary for small dipstick port.