Service manual

ATX 300 Plus Boost Operation Manual | Version 1 | September 2011 Robert Bosch LLC
10 | Cooler Mode | +1/2 Quart
Disconnecting from the Transmission System
Caution
Hoses, fitting adapters and the engine may be extremely hot.
Use extreme caution when disconnecting.
1. Turn vehicle engine off. READY light should go off. Make sure READY light is OFF before proceeding.
2. Disconnect ATX 300 PLUS BOOST from the vehicle battery.
3. Disconnect 10 ft black and red hoses from the 12 inch adapter hoses.
4. Disconnect 12 inch adapter hoses from fitting adapters connected to the transmission system.
5. Disconnect fitting adapters from the transmission system connection points.
6. Reconnect cooler lines. Do not cross-thread cooler line fittings when reconnecting to the transmission system.
7. Start vehicle engine and check for leaks at cooler line connection points, tighten if necessary. Vehicle transmission
service is complete once transmission system is leak free.
Good Practice
Empty used fluid tank after every exchange procedure.
+1/2 Quart
1. Vehicle engine is running and the ATX 300 PLUS BOOST is connected as previously described, READY light
is illuminated.
2. Check transmission dipstick. Light on COOLER MODE button should be illuminated. Press the +1/2 QUART
button to raise the fluid level if the transmission system is under filled.
3. When process is complete the buzzer will sound continuously and the PROCESS COMPLETE light will stay
illuminated until the STOP button is pressed.
4. Check transmission dipstick for appropriate level.