System information

Connecting an extension microphone 99

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Audio Conference Phone 2033 that you want

to replace.

3 Follow to install the IP Audio Conference Phone 2033. To

configure the IP Phone, see “Manual provisioning of IP Phone

2000 Series” (page 495).

4 Enter the same TN and Node Number as the IP Audio

Conference Phone 2033 you replaced. The system associates

the new IP Audio Conference Phone 2033 with the existing TN.

--End--

Removing an IP Audio Conference Phone 2033 from service

Procedure 21

Removing an IP Audio Conference Phone 2033 from service

Step Action

1 Disconnect the IP Audio Conference Phone 2033 from the

network or turn off the power.

If the IP Audio Conference Phone 2033 was automatically

configured, the DHCP lease expires and the IP address returns

to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 2033

TN: LLL S CC UU

--End--

Connecting an extension microphone

Procedure 22

Connecting an extension microphone to the IP Audio Conference Phone

2033

Step Action

1 Thread the microphone cord through the channels on the bottom

of the IP Phone.

A maximum of two microphone jacks are supported on the IP

Audio Conference Phone 2033.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009