System information

Installation and configuration 95

3 Configure the IP Audio Conference Phone 2033 in Element

Manager. IP Phones are configured using the Phones section

in the Element Manager navigation tree. For more information

about configuring the IP Audio Conference Phone 2033 using

Element Manager, see

Element Manager System Reference -

Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 18 “Connecting the components” (page 95) to connect the

components for the IP Phone.

Procedure 18

Connecting the components

Step Action

1 Connect one end of the CAT5d Ethernet cable to the network

interface located on the back of the Power over Ethernet (PoE)

module. See Figure 16 "POE module" (page 96). Plug the other

end of the CAT5e Ethernet cable into your IP network interface.

2 Connect the CAT5e Ethernet cable attached to the PoE module

to the IP Phone. Thread the CAT5e Ethernet cable through the

channel on the bottom of the IP Phone and plug it into the PoE

module port on the IP Phone.

The PoE module port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation.

3 Connect the AC power adapter (optional) to the power supply

port located on the back of the PoE module, Leave the AC

power adapter unplugged from the power outlet. Thread the

cord through the channel on the bottom of the PoE module then

plug the other end into the AC power source. Ensure you use

the correct AC power transformer. The voltage rating of the

transformer must match the wall outlet voltage. See Table 18

"Components list for US, CA, CALA, AP, and GC" (page 91) or

Table 19 "Components list for EMEA" (page 92).

Figure 16 "POE module" (page 96) shows the Power over

Ethernet (PoE) module.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009