System information

94 Nortel IP Audio Conference Phone 2033

• If an AC power adapter is required, ensure you use the correct AC

power transformer. The voltage rating of the transformer must match

the wall outlet voltage. See Table 18 "Components list for US, CA,

CALA, AP, and GC" (page 91) or Table 19 "Components list for EMEA"

(page 92).

• Ensure the latest IP Phone firmware is deployed to the IP telephony

node. For more information, see Signaling Server IP Line Applications

Fundamentals (NN43001-125).

First-time installation

You must first install an IP telephony node with the Communication Server.

For information about installing an IP telephony node, see Signaling Server

IP Line Applications Fundamentals (NN43001-125).

CAUTION

Service Interruption

Do not plug your IP Audio Conference Phone 2033 into an ISDN

connection. Severe damage can result.

Conﬁguring the IP Audio Conference Phone 2033

Use Procedure 17 “Configuring the IP Audio Conference Phone 2033”

(page 94) to configure the IP Audio Conference Phone 2033 for the first

time.

Procedure 17

Conﬁguring the IP Audio Conference Phone 2033

Step Action

1 Configure a virtual loop on the system using LD 97.

For more information about configuring a virtual loop, see

Signaling Server IP Line Applications Fundamentals (NN430

01-125) and Software Input Output Reference-Administration

(NN43001-611).

2 Configure the IP Audio Conference Phone 2033 on the system

using LD 11. At the prompts, enter the following:

REQ:new

TYPE:2033

TN lll s cc uu

ECHG yes

ITEM cls

ITEM

For more information about configuring the IP Audio Conference

Phone 2033 using LD 11, see Software Input Output

Reference-Administration (NN43001-611).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009