System information

Removing an IP Phone 2004 from service 71

4 Enter the password at the password screen, and press OK.

A TN screen displays.

To obtain the password, enter the nodePwdShow command in

Element Manager. For further information, see

Element Manager

System Reference - Administration (NN43001-632).

5 Select the Clear soft key to clear the existing TN.

6 Enter the new TN.

--End--

Replacing an IP Phone 2004

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

2004 that currently uses the TN.

Procedure 14

Replacing an IP Phone 2004

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 2004 that you want to replace.

3 Follow to install the IP Phone 2004. To configure the IP Phone,

see “Manual provisioning of IP Phone 2000 Series” (page 495).

4 Enter the same TN and Node Number as the IP Phone 2004 you

replaced. The Call Server associates the new IP Phone 2004

with the existing TN.

--End--

Removing an IP Phone 2004 from service

Procedure 15

Removing an IP Phone 2004 from service

Step Action

1 Disconnect the IP Phone 2004 from the network or turn the

power off.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 2004.

If the IP Phone 2004 was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009