System information

Installation and configuration 69

Figure 9

IP Phone 2004 Ethernet network connections

4 Connect the AC power adapter (optional). Leave the AC adapter

unplugged from the power outlet, connect the adapter to the AC

adapter jack in the bottom of the phone. Form a small bend in

the cable and then thread the adapter cord through the channels

in the stand.

5 Secure the IP Phone footstand to the base of the IP Phone. Use

the angle adjustment grip on the top back of the IP Phone to

adjust the position.

6 Power the IP Phone 2004 using either the Power over Ethernet

or an AC power transformer (local power). If you are using local

power, plug the AC power transformer into the nearest power

outlet. Make sure you use the correct AC power transformer is

used. The voltage rating of the transformer must match the wall

outlet voltage. See Table 12 "IP Phone 2004 component list"

(page 64).

The IP Phone 2004 supports both AC power and Power over

LAN options, including IEEE 802.3af Power Classification 2.

To use Power over Ethernet, where power is delivered over

the CAT5e cable, the LAN must support Power over Ethernet,

and an AC adapter is not required. To use local AC power, the

optional AC adapter can be ordered separately.

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009