System information

Installation and configuration 67

First-time installation

You must first install an IP telephony node with the Communication Server.

For information about installing an IP telephony node, see Signaling Server

IP Line Applications Fundamentals (NN43001-125).

CAUTION

Do not plug your IP Phone 2004 into an ISDN connection.

Severe damage can result.

Conﬁguring the IP Phone 2004

Use Procedure 11 “Configuring the IP Phone 2004” (page 67) to configure

the IP Phone 2004 for the first time.

Procedure 11

Conﬁguring the IP Phone 2004

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see

Signaling Server IP Line Applications Fundamentals (NN430

01-125) and Software Input Output Reference-Administration

(NN43001-611).

2 Configure the IP Phone 2004 on the Call Server using LD 11. At

the prompt, enter the following:

REQ:new

TYPE:2004P1,2004P2

For more information about configuring the IP Phone 2004 using

LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 2004 in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 2004 using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 12 “Connecting the components” (page 68) to connect the

components for the IP Phone.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009