System information

66 Nortel IP Phone 2004
IP Phone 2002/2004 Power Adapters
3 m (9.9 ft), 125 VAC, Option 11C
Denmark power cord
Denmark
NTTK22ABE6 NTTK22AB
Argentina N/A A0814961
1.8 m (5.9 ft), 10 amp, IEC320-C13
Japan
NTTK26AAE6 N/A
For more information, and for information about previous versions of the IP
Phone, contact your Nortel representative.
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 2004:
•
“Before you begin” (page 66)
•
“First-time installation” (page 67)
•
“Configuring the IP Phone 2004” (page 67)
•
“Connecting the components” (page 67)
•
“Startup sequence” (page 70)
Before you begin
Before installing the IP Phone 2004, complete the following pre-installation
checklist:
•
Ensure one IP Phone 2004 boxed package exists for each IP Phone
2004 you install. For a list of IP Phone 2004 package components, see
Table 11 "Package components" (page 64).
• Ensure one Software License exists for each IP Phone 2004 you
install.
•
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
• If an AC power adapter is required, ensure you use the correct AC
power transformer. The voltage rating of the transformer must match
the wall outlet voltage. See Table 12 "IP Phone 2004 component list"
(page 64).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.