System information

Updating IP Phones firmware 599
Procedure 159
Upgrading the firmware using BootC
Step Action
1 Hold down the [Up] and [2] keys, and while doing so, repower
the phone. When the phone restarts, it loads and runs BootC
instead of the application. When the Msg Waiting LEDs go off,
you can release the [Up] and [2] keys.
2 The following text menu on a white background appears:
11x0 IP Phone
Manual Configuration
Nortel
If you do not see this message, you are in the wrong menu.
Repeat step 1. If BootC is damaged from a power reset, hold
down the [Up] and [3] keys to use the backup BootC.
3 When Nortel appears on the screen, press the soft keys 1,2,3,4
in sequence (left to right). BootC goes to manual configuration. If
you miss this step, and the phone begins to register to the TPS,
repeat step 1.
4 Follow the prompts to configure DHCP and other IP parameters
or, if DHCP and other parameters are already configured, just
continue pressing the 1 soft key or OK. The soft keys functions
are listed below:
• soft key 1 (below the LCD) is OK
• soft key 2 is BackSpace
•
soft key 3 is Clear
• soft key 4 is Cancel
5 When prompted: TFTP Dwnld? (0-No, 1-Yes):0,
•
Press soft key 2 (BKSpace) to clear the 0 (No).
•
Press 1 on the dialpad, then press soft key 1 (OK).
6 When prompted: TFTP IP xxx.xxx.xxx.xxx,
• If the IP address is correct for the TFTP server, press soft key
1 (OK). After the TFTP address is entered the first time, it is
presented the next time you enter the menu.
• If the IP address is incorrect, press soft key 2 (Clear) to erase
the address shown and enter a new address. Press the
asterisk (*) key to enter a period (.) in the IP address. You
can also use backspace key to erase part of the address or
correct errors by pressing soft key 1 (BKSpace). When the
address is correct, press soft key 1 (OK).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.