System information

ManualsBrandsBoots ManualsGadgetsCS-1000

591

592

593

594

595

596

597

598

599

600

598 TFTP Server

• Access the Network Configuration menu. Enter the address

at the TFTP IP prompt. Press the ApplyandReset soft key to

save the change.

•

Enter the address in the BootC menu. See “Manual TFTP

Download from BootC Procedure” (page 598).

BootC idz_8958 is not available for Expansion Modules for

IP Phones 1100 Series.

•

Enter the IP address in the TFTP IP address field retrieved

by the DHCP Server.

2 Restart the phone.

After the IP Phone starts and begins to run the latest version

of firmware, the 1110.cfg, 1120e.cfg, 1140e.cfg, 1150e.cfg,

1210.cfg, 1220.cfg, and 1230.cfg files are downloaded

from the TFTP Server. After the .cfg file is retrieved, the

DOWNLOAD_MODE and VERSION fields are checked. If

necessary, the firmware file is transferred to the phone using

TFTP. The display shows the message

[FW] reading... If

successful, the display shows [FW] writing... and the blue LED

starts to flash. After the FW image is written to the phone, the

message [FW] finished displays, the blue LED stops flashing,

and the phone resets. The phone registers to the TPS with the

new FW version.

--End--

Manual TFTP Download from BootC Procedure

This method of upgrading the firmware is normally used only when you

need to force the phone to restore an older firmware version. To use this

method, the firmware must be placed on the TFTP Server, and you must

manually configure the phone to point to that TFTP Server. The BootC

firmware carries out the upgrade. To initiate the firmware download task,

BootC must be triggered to run.

You can create the configuration file with a default file name, such as

1140E.img so you do not have to change the file name each time a new

IP Phone 1140E firmware load is released. However, if you take this

approach, be sure to rename the released firmware file (for example,

0625Cxx.bin) to the default file name when the new firmware file is copied

into the TFTP Server root directory and to update the VERSION string in

the configuration file.

After the configuration file and the image file are in the TFTP Server root

directory, use Procedure 159 “Upgrading the firmware using BootC” (page

599) to upgrade the firmware using BootC.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009