System information

Installation and configuration 51

For more information about configuring a virtual loop, see

Signaling Server IP Line Applications Fundamentals (NN430

01-125) and Software Input Output Reference-Administration

(NN43001-611).

2 Configure the IP Phone 2002 on the Call Server using LD 11. At

the prompt, enter the following:

REQ:new

TYPE:2002P1,2002P2

For more information about configuring the IP Phone 2002 using

LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 2002 in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 2002 using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 7 “Connecting the components” (page 51) to connect the

components for the IP Phone.

Procedure 7

Connecting the components

Step Action

1 Connect one end of the handset cord to the handset jack on the

back of the IP Phone (identified with a handset icon). See Figure

6 "IP Phone 2002 Ethernet network interface connections" (page

52)

2 Connect the other end of the handset cord to the handset.

3 Choose one of the following connections:

• For an IP Phone not sharing LAN access with a PC:

Connect one end of the CAT5e Ethernet cable to the network

interface located on the back of the IP Phone (identified with

a LAN icon). The other end of the CAT5e Ethernet cable

plugs into the IP network.

• For an IP Phone sharing LAN access with a PC:

Connect one end of the CAT5e Ethernet cable to the network

interface located on the back of the IP Phone (identified with

a LAN icon) and the other end to the IP network. Insert on

end of a second CAT5e Ethernet cable into the PC network

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009