System information

50 Nortel IP Phone 2002

• “Connecting the components” (page 51)

• “Startup sequence” (page 53)

Before you begin

Before installing the IP Phone 2002, complete the following pre-installation

checklist:

•

Ensure one IP Phone 2002 boxed package exists for each IP Phone

2002 you install. For a list of IP Phone 2002 package components, see

Table 7 "Package components" (page 48).

•

Ensure one Software License exists for each IP Phone 2002 you

install.

• Ensure the host Call Server is equipped with a Signaling Server that

runs the Line Terminal Proxy Server (LTPS) application.

•

If an AC power adapter is required, ensure you use the correct AC

power transformer. The voltage rating of the transformer must match

the wall outlet voltage. See Table 8 "IP Phone 2002 components list"

(page 48).

•

Ensure the latest IP Phone firmware is deployed to the IP telephony

node. For more information, see Signaling Server IP Line Applications

Fundamentals (NN43001-125).

First-time installation

You must first install an IP telephony node with the Communication Server.

For information about installing an IP telephony node, see Signaling Server

IP Line Applications Fundamentals (NN43001-125).

CAUTION

Do not plug your IP Phone 2002 into an ISDN connection.

Severe damage can result.

Conﬁguring the IP Phone 2002

Use Procedure 6 “Configuring the IP Phone 2002” (page 50) to configure

the IP Phone 2002.

Procedure 6

Conﬁguring the IP Phone 2002

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009