System information

Automatic provisioning 473

REG= 00:1B:BA:F8:82:1F CS1K S1 7777 096-1-22-05;

REG= 00:1B:BA:F8:82:2D CS1K S1 7777 096-1-22-06;

REG= 00:1B:BA:F8:82:2E CS1K S1 7777 096-1-22-07;

REG= 00:1B:BA:F8:82:2F CS1K S1 7777 096-1-22-08;

REG= 00:1B:BA:F8:82:3D CS1K S1 7777 096-1-22-09;

reg= 00 1B BA F8 82 3E CS1K S1 7777 096-1-22-10;

reg= 001BbaF8823f Cs1k s1 8972 61 0;

reg= 00-1b-Ba-f8-82-4d cs1k S1 3434 96 00 01 11;

Automatic provisioning using UNIStim You can use UNIStim to

automatic provision a limited number of parameters, such as Layer 2

priority bits (Ctrl and Media priority bits) and Differentiated Service Code

Point (DiffServ). For information about configuring these parameters, see

Signaling Server IP Line Applications Fundamentals (NN43001-125).

Provisioning Info Block

You can obtain configuration parameters in the IP Phone that are defined

as AUTO from the Auto Provisioning page from an 802.1ab switch (LLDP),

DHCP, TFTP, or UNIStim.

You can obtain the configuration options in the following priority, from

lowest to highest:

• Manual provisioning

•

Automatic provisioning using 802.1ab switch (LLDP)

• Automatic provisioning using TFTP

— Current device-specific Provisioning Info Block carried by the

provisioning server

— Current zone-specific Provisioning Info Block sent by the

provisioning server

— Current type-specific Provisioning Info Block sent by the

provisioning server

— Current system-specific Provisioning Info Block sent by the

provisioning server

• Automatic provisioning using DHCP

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009