System information

Redeploying an IP Phone 2001 37

Startup sequence

When an IP Phone 2001 connects to the network, it must perform a startup

sequence. The elements of the startup sequence include:

• obtaining network access (if supported by the network infrastructure)

• obtaining VLAN ID (if supported by the network infrastructure)

• obtaining the IP parameters

•

connecting to the Call Server

• obtaining the provisioning parameters

For information about provisioning the IP Phone, see “Manual provisioning

of IP Phone 2000 Series” (page 495).

Redeploying an IP Phone 2001

You can redeploy an existing previously configured IP Phone 2001 on

the same system. For example, the IP Phone 2001 can be assigned to

a new user (new TN) or to an existing user who moved to a new subnet

by changing the TN of the IP Phone 2001. For further information, see

Converging the Data Network with VoIP Fundamentals (NN43001-260).

Procedure 3

Changing the TN of an existing IP Phone 2001

Step Action

1 Repower the IP Phone 2001.

During the reboot sequence of a previously configured IP

Phone, the IP Phone 2001 displays the existing node number

for approximately five seconds.

2 If the node password is enabled and NULL, choose one of the

following:

a Disable the password.

b Set the password as non-NULL.

3 Press OK when the node number displays.

If Then

the node password is enabled

and is not NULL

a password screen displays. Go

to Step 4.

the node password is disabled a TN screen displays. Go to Step

4 Enter password at the password screen, and press OK.

A TN screen displays.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009