System information

Installation and configuration 347
Before you begin
Before installing the IP Phone 1150E, complete the following
pre-installation checklist
• Ensure one IP Phone 1150E boxed package exists for each IP Phone
1150E you install. For a list of IP Phone 1150E package components,
see Table 78 "Package components" (page 345).
•
Ensure one Software License exists for each IP Phone 1150E you
install.
• Ensure the host Call Server is equipped with a voice Gateway Media
Card and a Signaling Server with the Line TPS application.
•
If an AC power adapter is required, ensure the approved Nortel global
power supply (model number N0089601) is used. See Table 79 "IP
Phone 1150E component list" (page 345).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1150E into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 1150E
Use Procedure 92 “Configuring the IP Phone 1150E” (page 347) to
configure the IP Phone 1150E.
Procedure 92
Configuring the IP Phone 1150E
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 1150E on the Call Server using LD 11.
At the prompt, enter the following:
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.