System information

310 Nortel IP Phone 1120E
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see
Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 1120E
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1120E that currently uses the TN.
Procedure 85
Replacing an IP Phone 1120E
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1120E that you want to replace.
3 Follow to install the IP Phone 1120E. To configure the IP Phone,
see “Manual provisioning of IP Phone 2007 and 1100 Series”
(page 487).
4 Enter the same TN and Node Number as the IP Phone 1120E
you replaced. The Call Server associates the new IP Phone
1120E with the existing TN.
--End--
Removing an IP Phone 1120E from service
Procedure 86
Removing an IP Phone 1120E from service
Step Action
1 Disconnect the IP Phone 1120E from the network or turn off the
power.
The service to the PC is disconnected as well if the PC connects
to the IP Phone 1120E.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.