System information

Removing an IP Phone 1110 from service 291
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 1110
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1110 that currently uses the TN.
Procedure 80
Replacing an IP Phone 1110
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1110 that you want to replace.
3 Follow to install the IP Phone 1110. To configure the IP Phone,
see “Manual provisioning of IP Phone 1110 and 1200 Series”
(page 479).
4 Enter the same TN and Node Number as the IP Phone 1110 you
replaced. The Call Server associates the new IP Phone 1110
with the existing TN.
--End--
Removing an IP Phone 1110 from service
Procedure 81
Removing an IP Phone 1110 from service
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.