System information

Installation and configuration 287

Figure 45

IP Phone 1110 connections

4 Install the handset. Connect the end of the handset cable with

the short straight section into the handset. Connect the end of

the handset cable with the long straight section to the back of the

phone, using the RJ-9 handset jack. Form a small bend in the

cable, and then thread the handset cord through the channels in

the stand so that it exits behind the handset on the right side, in

the channel exit in the stand base. See Figure 46 "Cable routing

tracks" (page 288).

Although a headset cord channel appears on the base of the

IP Phone 1110, the IP Phone 1110 does not support a headset

port.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009