System information

Installation and configuration 283
Table 62
IP Phone 1110 components list (cont’d.)
Component
Product code
Argentina N/A A0814961
1.8 m (5.9 ft), 10 amp, IEC320-C13
Japan
NTTK26AAE6 N/A
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1110
•
“Before you begin” (page 283)
• “First-time installation” (page 283)
•
“Configuring the IP Phone 1110” (page 284)
•
“Connecting the components” (page 284)
•
“Startup sequence” (page 289)
Before you begin
Before installing the IP Phone 1110, complete the following pre-installation
checklist
•
Ensure one IP Phone 1110 boxed package exists for each IP Phone
1110 you install. For a list of IP Phone 1110 package components, see
Table 61 "Package components" (page 281).
•
Ensure one Software License exists for each IP Phone 1110 you
install.
•
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
•
If an AC power adapter is required, ensure the approved Nortel AC
adapter (model number N0089601) is used. See Table 62 "IP Phone
1110 components list" (page 282).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.