System information

166 Nortel IP Phone 1230
Configuring the IP Phone 1230
Use Procedure 39 “Configuring the IP Phone 1230” (page 166) to
configure the IP Phone 1230 for the first time.
Procedure 39
Configuring the IP Phone 1230
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 1230 on the Call Server using LD 11. At
the prompt, enter the following commands:
REQ:new
TYPE:1230
For more information about configuring the IP Phone 1230 using
LD 11, see Software Input Output Reference-Administration
(NN43001-611).
3 Configure the IP Phone 1230 in Element Manager. IP Phones
are configured using the Phones section in the Element
Manager navigation tree. For more information about configuring
the IP Phone 1230 using Element Manager, see Element
Manager System Reference - Administration (NN43001-632).
--End--
Connecting the components
Use Procedure 40 “Connecting the components” (page 166) to connect the
components for the IP Phone. See Figure 31 "IP Phone 1230 connections"
(page 167).
Procedure 40
Connecting the components
Step Action
1 Attach the footstand (optional). Attach the foot stand in the
appropriate slots depending on the desired angle for your IP
Phone. If you insert the foot stand into the upper slots, your IP
Phone sits at a 25-degree angle. If you insert the foot stand into
the lower slots, your IP Phone sits at a 55-degree angle.
If you install the IP Phone on the wall, do not attach the
footstand.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.