System information

130 Nortel IP Phone 1210
• If an AC power adapter is required, ensure you use the approved
Nortel global power supply (model number N0089601).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
CAUTION
Ensure that the protective rubber cap on the Accessory
Expansion Module (AEM) port is in place when the port is not
in use. An improper connector can cause damage to the IP
Phone.
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Do not plug your IP Phone 1210 into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 1210
Use Procedure 29 “Configuring the IP Phone 1210” (page 130) to
configure the IP Phone 1210 for the first time.
Procedure 29
Configuring the IP Phone 1210
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 1210 on the Call Server using LD 11. At
the prompt, enter the following command:
REQ:new
TYPE:1210
For more information about configuring the IP Phone 1210 using
LD 11, see Software Input Output Reference-Administration
(NN43001-611).
3 Configure the IP Phone 1210 in Element Manager. IP Phones
are configured using the Phones section in the Element
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.