System information

116 Nortel IP Phone 2007

Connect one end of the CAT5e Ethernet cable to the LAN

Ethernet port located on the back of the IP Phone and the

other end to the IP network. Insert one end of a second

CAT5e Ethernet cable into the PC Ethernet port located on

the back of the IP Phone and the other end into the computer

Ethernet port.

The LAN Ethernet port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

4 Secure the IP Phone footstand to the base of the IP Phone. Use

the angle adjustment grip on the top back of the IP Phone to

adjust the position.

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 2007

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 2007 does not

support multiple devices connected through the PC

Ethernet port.

Figure 22

IP Phone 2007 connections

5 Power the IP Phone 2007 using either the Power over Ethernet

or the Global power adapter (local power).

a To use local power, plug the Global power adapter into

the nearest power outlet. See Table 26 "IP Phone 2007

component list" (page 113).

b Connect the power jack as shown in Figure 22 "IP Phone

2007 connections" (page 116).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.02 26 May 2009