System information

Installation and configuration 115
Procedure 24
Configuring the IP Phone 2007
Step Action
1 Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 2007 on the system using LD 11. At the
prompt, enter the following:
REQ:new
TYPE:2007
To configure the IP Phone 2007 using LD 11, see Software Input
Output Reference-Administration (NN43001-611).
3 Configure the IP Phone 2007 in Element Manager. IP Phones
are configured using the Phones section in the Element
Manager navigation tree. For more information about configuring
the IP Phone 2007 using Element Manager, see Element
Manager System Reference - Administration (NN43001-632).
--End--
Connecting the components
Use Procedure 24 “Configuring the IP Phone 2007” (page 115) to connect
the components for the IP Phone.
Procedure 25
Connecting the components
Step Action
1 Connect one end of the handset cord to the handset jack on the
back of the IP Phone (identified with a handset icon).
2 Connect the other end of the handset cord to the handset.
3 Choose one of the following connections:
• For an IP Phone not sharing a LAN access with a PC:
Connect one end of the CAT5e Ethernet cable to the LAN
Ethernet port located on the back of the IP Phone (identified
with a LAN icon). Plug the other end of the CAT5e Ethernet
cable into the IP network.
• For an IP Phone sharing a LAN access with a PC (identified
with a PC icon):
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.