System information

114 Nortel IP Phone 2007
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 2007:
• “Before you begin” (page 114)
• “First-time installation” (page 114)
• “Configuring the IP Phone 2007” (page 114)
•
“Connecting the components” (page 115)
• “Startup sequence” (page 117)
Before you begin
Before installing the IP Phone 2007, complete the following pre-installation
checklist:
•
Ensure one IP Phone 2007 boxed package exists for each IP Phone
2007 you install. For a list of IP Phone 2007 package components, see
Table 25 "Package components" (page 113).
• Ensure one Software License exists for each IP Phone 2007 you
install.
• Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
•
If you are not using Power over Ethernet (PoE) you must use the
Global power adapter or your phone fails to operate. See Table 26 "IP
Phone 2007 component list" (page 113).
•
Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 2007
Use Procedure 24 “Configuring the IP Phone 2007” (page 115) to
configure the IP Phone 2007.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.02 26 May 2009
Copyright © 2003-2009 Nortel Networks. All Rights Reserved.
.