Troubleshooting guide

Tracer
Boost Technology Page 7 of 13
For Desktop Use
1. Place the transmitter on a flat surface or mouse pad.
2. Move the transmitter around on the surface as you would a normal computer mouse. The transmitter will
automatically sense the motion of the mouse ball and allow it to control the cursor. It may take a few seconds to
switch control from the visor to the ball. (Even if the visor is not plugged in, it defaults to "hands-free" mode.)
3. If you stop moving the mouse, the gyroscope in the visor will be reactivated in less than five seconds.
The Holster
The Holster provides a means to attach the transmitter to a chair, keeping it out of the way while allowing comfortable use of the
visor. The holster will secure the transmitter best when installed facing up, but will also hold it facing "sideways". There are several
ways to attach the cradle, user preference dictates the final choice of orientation and location. Refer to the illustration below while
following these instructions.
To mount on a frame member: The most secure attachment for the holster is on the frame of the chair.
1. Feed the supplied 3/4 inch wide velcro straps through the two pairs of slits on the back of the holster, as shown on
the left below.