Specifications

2.2 Optional Accessories

Remote Meter(Model：MT-2)

The digital Remote Meter displays system operating information, error

indications, and self-diagnostics read-out. Information is displayed on a backlit LCD

display. The large numerical display and icons are easy to read and large buttons make

navigating the meter menus easy. The meter can be flush mounted in a wall or surface

mounted using the mounting frame (included). The MT-2 is supplied with 1.5m of

cable and a mounting frame. The MT-2 connects to the RJ45 port on the TRACER.

3 Installation Instructions

3.1 General Installation Notes

·Read through the entire installation section first before beginning installation.

· Be very careful when working with batteries. Wear eye protection. Have fresh water

available to wash and clean any contact with battery acid.

· Use insulated tools and avoid placing metal objects near the batteries.

· Explosive battery gasses may be present during charging. Be certain there is

sufficient ventilation to release the gasses.

· Do not install in locations where water can enter the controller.

· Loose power connections and/or corroded wires may result in resistive connections

that melt wire insulation, burn surrounding materials, or even cause fire. Ensure

tight connections and use cable clamps to secure cables and prevent them from

swaying in mobile applications.

· Only charge sealed, gel or flooded batteries.

· TRACER Battery connection may be wired to one battery or a bank of batteries. The

following instructions refer to a singular battery, but it is implied that the battery

connection can be made to either one battery or a group of batteries in a battery bank.

3.2 Mounting

NOTE: When mounting the TRACER, ensure free air through the controller

heat sink fins. There should be at least 6 inches (150 mm) of clearance above and

below the controller to allow for cooling. If mounted in an enclosure, ventilation

is highly recommended.

WARNING: Risk of explosion! Never install the TRACER in a sealed enclose

with flooded batteries! Do not install in a confined area where battery gassed

can accumulate.