Instruction manual

To intake manifold -
use small Tee to tap into
an existing vacuum hose
if necessary
1/8” I.D. vacuum hose
Vacuum hose joiner
Loom
Boost Control
Solenoid
Black wire -
Vehicle ground (chassis)
Red wire -
+12V switched power source
Blue wire - External input
(see notes below, and
pages 12 & 14 for details)
Optional Remote Trigger Circuit
Engine Bay
Vehicle Interior
Yellow wire - not used, future features
(see notes below)
Remote trigger button (not
supplied). Use any switch, button
or sensor that grounds the blue
wire when activated
The external input can be used as a remote trigger simply by connecting it to any kind of switch, button, or programmable ECU output
that grounds the blue wire to the vehicle earth when activated. For ideas on different ways to use the external input, see page 14. Once
connected, the purpose of the external input must be configured within the “INPUT” sub-menu within the menu (see page 12).
The yellow wire currently has no purpose, it is intended for use with future features.
If either the blue or yellow wire are not used, simply cut or bundle them and make sure they are insulated.
WARNING!
Do NOT connect the blue or yellow wire to a 12V source as this could damage the unit.
3 - installation
wiring diagram
BOOST
SCRAMBLE
MENU