Technical Specs

3. Device management
The device is switched ON and OFF by bringing the screwdriver handle with a magnet into the light indication area. The Hall
sensor HS1 is responsible for turning on, and HS2 for turning off. A timer shutdown is also possible, the default value is 30 min,
which can be configured via the APP. The device also turns off automatically when the battery is completely discharged.
Turning on and off the motor is controlled by a radio remote control with two buttons.
Button A turns on the Short boost mode, button B turns on the Long boost mode.
Pressing any of the buttons again turns off the motor.
The battery voltage is monitored through circuit the R6, R7, D5, C24 , input ADC0 U2.
Device operating modes and battery level are indicated by RGB LED D3 according to the table below.
Radio remote control
Button BButton A