Technical Specs

6.4 Battery Pack LP6S1P15A15AL01
Description:
LP6S1P15A15AL01 is a 6S1P Lithium-Ion rechargeable Battery Pack with Battery Management System integrated, norminal
voltage at 22.2V, rated capacity at 3.5Ah, with 23cm long 22AWG open wires for charge, with 16AWG 6cm long wires and
terminated with ESC 3.5 female connector for discharge, charge & discharge from the different terminals, with anti-reverse 2A
diode built on charging positive wire (at 8cm position from bengnning of the wire) .
- Battery Cell: SAMSUNG 18650 35ET
- BMS: BesTech Power 6S20AF-V0
Specification Battery:
- Capacity: Nominal Capacity: 3.5Ah
Minimum Capacity: 3.4Ah
- Nominal Voltage: 22.2V
- Internal impedance: < 300 mOhm
- Discharge Cut-off Voltage: 16.80V
- Max Charge Cut-off Voltage: 25.2V
- Max. Continuous Charge Current: 1.5A
- Max. Continuous Discharge Current: 20A
- Max. Discharge Peak Current: 30A for several seconds foe starup
- Cycle Life: >500 cycles, after 500 cycles in 90% DOD charge and discharge at rated current,
The residual discharge capacity is above 80% of nominal capacity
- Protection: All protection adopted of the BMS
- Weight: 420g+- 10g
- Max. Dimension: 115 x 72 x 20 mm (L*W*T) ( Dimension tolerance +-3mm)
- Operation Temperature: Charge: 0 C ~ 45 C
Discharge: -20 C ~ 60 C
Specification BMS:
- Over charge protection voltage: 4.20V +- 25mV
- Over charge recovery voltage: 4.10V +- 50mV
- Over charge protection delay time: 80ms - 120ms
- Over discharge protection voltage: 2.8V +- 50mV
- Over discharge recovery voltage: 2.8V +- 100mV
- Max. continuous discharge & charge current: 20A discharge & 1.5A charge
- Over current protection current: Discharge: 45-60A, Charge: 7-10A
- Over discharge protection delay time: 40ms – 100ms
- Short-circuit protection delay time: 10ms – 20ms
- Static self-consumption current: I<6.0uA
- PCB internal resistance: R<65mOhm
- Passive balansing: 126mA+-15mA @ 4.18V+- 0.025
- Temperature switch / NTC: H: 50C+-5C & L: - 3C +- 2C