Owner's Manual

4.) Remove the paper release liner
from the back of the part about to be
installed. Once the liner is removed,
center one side as shown in Figure 3.
5.) Once the starting edge is adhered, lay down
the rest of the part by applying gentle pressure
by hand as shown in Figure 4.
Figure 3. Center part from one side
Figure 4. Lay panel in place by applying gentle pressure
T
H
E
R
M
A
L
A
C
O
U
S
T
I
C
C
O
N
T
R
O
L
www.BoomMat.com
800-264-9472
INS-3006 rev 6/16