Service manual

is07755

1. Clip, push-in (3)

2. Amplifier cover

Figure 10. Amplifier Cover

4. Install the saddlebags. Plug in all saddlebag connectors.

5. Attach the new saddlebag capacity label (12) over the

existing label in the right saddlebag. Note the revised load

limit for the right saddlebag due to the amplifier installation.

6. See the service manual. Install the wire trough cover.

7. Install the fuel tank per the service manual. Install the fuel

tank console.

8. Install the electrical caddy under the left side cover with

the two bolts removed earlier. Tighten the bolts to 72-96

in-lbs (8.1-10.8 N-m).

9. Install left side cover.

10. Install right side cover.

COMPLETION

NOTE

To prevent possible damage to the sound system, verify that

the ignition switch is OFF before attaching the battery cables.

Connect positive (+) battery cable first. If positive (+) cable

should contact ground with negative (-) cable connected,

the resulting sparks can cause a battery explosion, which

could result in death or serious injury. (00068a)

1. See the service manual. Connect the battery terminal

branch to the battery terminals (red positive cable first).

a. Position the + ring terminal onto the positive battery

terminal. Install the bolt.

b. Position the in-line fuse holder in a location that can

be easily accessed.

c. Position the - ring terminal onto the negative battery

terminal. Install the bolt.

d. Tighten both bolts to 60-70 in-lbs (6.8-7.9 N-m).

2. Apply a light coat of petroleum jelly or corrosion retardant

material to battery terminals.

3. Install the ECM caddy per the service manual.

After installing seat, pull upward on seat to be sure it is

locked in position. While riding, a loose seat can shift

causing loss of control, which could result in death or

serious injury. (00070b)

4. See the service manual. Install seat.

5. Install main fuse.

6 of 8-J06051