Service manual

1
2
3
is07750a
1. Area to be cleaned
2. Amplifier bracket
3. Tape strip (4)
Figure 6. Amplifier Bracket Installation
1
2
3
is07751
1. Amplifier
2. Pin stud
3. Grommets
Figure 7. Amplifier Pin Studs
11. See Figure 7. Install the amplifier pin studs in the amplifier.
Tighten to 7-9 ft-lbs (9.4-12.2 Nm). Install the grommets.
12. Position the amplifier with the grommets in the holes in
the bottom of the amplifier bracket. Slide the top into the
bracket. Install the two hex socket button head screws.
Tighten to 7-9 ft-lbs (9.4-12.2 Nm).
AMPLIFIER HARNESS INSTALLATION
NOTES
These tips help make sure all wiring fits under the seat, espe-
cially in multiple amplifier installations:
• Begin routing the vehicle-side amplifier harness from the
large 18-way amplifier connector [289-1B], moving forward
on the vehicle. The large connector does not fit through
narrower passages.
• Route all wire harnesses under the frame rail to avoid
pinching by covers or the seat.
• Take care to route ALL amplifier harness branches away
from spark plug wires. Close proximity induces spark noise
into the audio system.
• When routing wires from one side of the vehicle to the
other, tuck harnesses under the frame tray behind the
battery to keep the battery compartment accessible.
• Route the six-way black, pink-wired audio connectors
under the right frame rail, into the right side cover. Bundle
in front of the ABS module (if present).
• Route the six-way, gray Data Link Connectors (DLCs)
along the left frame rail. Bundle the connectors in a pocket
of the frame in front of the battery, under the wire trough
along the frame backbone.
1. See Figure 8. Route the vehicle-side amplifier harness (1)
in the saddlebag mounting area, beginning with the large
18-way amplifier socket connector [289-1A], moving for-
ward on the vehicle. Route the harness around the rear
brake rotor, following the saddlebag support rail.
1
2
3
4
is07757
1. Secondary Amplifier Harness (69201090)
2. Cable strap
3. Fender support
4. Connector [289-1A]
Figure 8. Harness Routing
2. Route the harness:
a. behind and underneath the frame,
b. into the underseat battery area.
3. Use cable straps (2) to tie the harness loosely to the
saddlebag support. Use the large hole near the saddlebag
rear attachment point or one of the cable strap slots along
the bottom of the support.
4 of 8-J06051