Instructions For Use Manual

33
33MANAGE Mode
33
Calibrate
To calibrate, the Power sensor must be turned on, then connected and paired. If
the NODE is currently showing CALIBRATE?, start with Step 4.
1. Enter MANAGE mode. Hold
B
for three seconds.
The Manage mode starts with the Bike Selection display.
2. Browse
s1
to power.
3. If needed, change Power to On. Press
s2
to change.
Press
s1
to save.
Hold
B
for three seconds to return to RIDE mode.
Perform a Force Pair: hold
s1
and
s2
for three seconds and make each
sensor send a signal.
Wait for the Force Pair to complete, then repeat step 1 and step 2.
4. If needed, change Calibrate? to Yes. Press
s2
to change.
To save your choice and proceed to the calibration process, press
s1
. When
the “Calibrating Power” shows on the screen, do one of the following:
For a Powertap power sensor, spin the wheel
For a SRM power sensor, spin the crankset backwards with no weight on the pedals
For a Quarq power sensor, do not spin the crank
5.Ifthecalibrationfails,thescreenrevertstoCalibrate?(step4).Referto
Troubleshootingonpage52.
If the calibration process passes, the Node goes to the Heart Rate screen.
Choose one of the following:
 •FollowtheinstructionstomanageHeartRateonpage34.
 •Toseeotherfunctions,browse
s1
.
 •ToreturntoRIDEmode,hold
B
for three seconds.
1.
3.
B
(3 seconds)
2.
s2
s2
s1
s1
4.
s1