Instructions For Use Manual

This section explains how to start a new ride. To start a ride, you must connect

the sensor and then either continue your previous ride or start a new ride.

Connecting the Sensor

Each time you wake the NODE or switch it to On, it automatically tries to

communicate with the sensor. This is called “connecting.” For the NODE to

connect to the speed sensor, the wheel must turn.

The display during Connecting

During the Connecting process, the display shows CONNECTING SENSORS

and the lower right corner of the display flashes the ‘receiving’ icon (Figure 24).

This process can take as long as a minute to complete. The NODE shows the

connectedsensorintheupperleftcornerofthedisplay(Figure25).

After connecting, the display shows NEW RIDE?

Force Connect

If your NODE did not connect correctly, you can “Force Connect,” making

the NODE repeat the connecting procedure. In Ride mode, hold

for three

secondsandthenmakethesensorsendasignal(Figure26).

Figure 24. Connecting to Sensors.

STARTING A RIDE

Figure 25. Connected Sensors.

Sensor icons

(3 seconds)

Figure 26. Force Connect.

1. 2.

NEW RIDE?

1. To change the value (choose YES or NO), press

2. To select, press

YES NO

Trip data Erased Saved

Trip Clock 0:00:00 Starts from previous time

Backlight SwitchestoOnfor5seconds

Switches to RIDE mode Switches to RIDE mode