Specifications

INO 36 DISHWASHER Code NU271700-11/97-Ind.B-01/99
Chap.5 - Page 3
SERVICE - SERVICE - SERVICE - SERVICE - SERVICE - SERVICE -
* REGENERATION___________________________________________________________________
* Check the filling of the regenerating salts vat
* The periodicity has been noted by the fitter in the *Open the door * Press the drain control switch
board below (option) or remove the
overflow tube.
It depends on the water hardness and
the quantity of racks of crockery washed per day
* When the tank is empty,
press the drain control switch
again, or place the overflow tube.
* Close the door
* Press the regeneration control switch during 2 to 3 seconds.
These data are just indications. The regeneration is necessary
if there is a white deposit on the glasses. The regeneration pilot light lights up
during the cycle (about 20 mn).
Before each regeneration check the quality of salt in the salt vat
(paragraph 3 - 4), the vat capacity allows three regeneration cycles.
When the pilot light is off
the regeneration is over.
* Drain the tank again
and switch off the appliance.
NOTA : The regeneration must only start when the tank is empty.
Warning : The start of the regeneration cycle forbids the dishwasher operation.
* REGENERATING SALTS VAT FILLING_____________________________________
- Fill the salt vat with a proper coarse salt or pastille. Close
the vat.
Degree Th 10 15 20 25 30 35 40
Nber. racks/ h
5 9 days 6 days 5 days 4 days 3 days 3 days
8 8 days 5 days 4 days 3 days 3 days
10 7 days 5 days 4 days 3 days
13 6 days 4 days 3 days
15 4 days 3 days
18 4 days
20 4 days
25 3 days
30 3 days
35 3 days
40
45
50
After each operati on
Every 2 days
Ev er
y
2 da
y
s