Technical data

26
Control unit / KP500
TheKP500controlunitisequippedwithaParametersCopyfunctionthatallowsthe
user to upload parametric values from the inverter to a non-volatile memory installed
intheKP500device,allowingthesamevaluestobesubsequentlydownloadedto
another inverter.
The control unit makes it possible to set up the inverter for specific applications and
allows the display of the service values of physical and electrical parameters.
The inverter can also be controlled from the control unit for start/stop and frequency
reference increase/decrease commands. Since the control unit is not essential for
inverter operation it can be connected when the user considers it useful or necessary.
Control unit remote installation kit / KPCMK
The KPCMK kit is used to remotely control the inverter
from the KP500 unit.
Remote installation on exterior of enclosure
Handheld remote control unit
Remote control cable
(3 metres)
SupportforKP500
control unit
KP500controlunit
Fixing to enclosure
4screwsK35x10mm
Rear cover of kit
Electrical enclosure wall
Cut-out 92 x 92 mm