Technical data
40
Optional modules
Even in their basic configuration, Agile drives are equipped with an on-board RJ45
connector for use with communications ports.
Nevertheless, if you wish to extend the opportunities for field network integration you
can install an optional module with an additional network interface.
Agile drives can therefore be integrated in existing fieldbus networks simply by
adapting drive communications to the hardware and software of the existing
communications standard.
Agile drives use exactly the same communication modules as Bonfiglioli’s Active and
Active Cube series. They also enjoy the same plug & play functionality, so that the drive
recognises and enables the new module automatically as soon as it is powered on.
Agile drives support various communication standards. Some of these do not require
any optional equipment while others require the corresponding module to be installed.
See the table alongside.
All optional modules are identical in shape and size, but differ in electronic functioning
according to the standards of the type of field bus they communicate with.
Communication modules are installed in slots in the front of the drive. Simply remove
the protective cover to access the slots. A secure push-fit ensures an efficient electrical
connection.
With the front panel removed, the DB9 connector for the mains connection module is
also accessible.
Field bus Optional module
CANopen CM-CAN
Profibus DP V1 CM-PDP
RS-232 CM-232
RS-485Modbus CM-485
DeviceNet CM-DEV
EtherCAT
®
CM-CAT
ProfiNet CM-PNET
VABus/TCP CM-VATCP
Logos
RS-232
RS-485Modbus
CANopen
Profibus DP V1
DeviceNet
EtherCAT
®
ProfiNet
VABus/TCP